Requirements, license levels, and the issuing authority, sourced from Georgia's official board.
Check which trade the specific work falls under before quoting in Georgia: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own.
| Requirements | GEORGIA DOES NOT ISSUE A SEPARATE SHEET METAL WORKER LICENCE. Only a small number of states, Massachusetts, with its own Board of Sheet Metal Workers, is the clearest example, license this trade in its own right. Elsewhere sheet metal work is regulated as part of the mechanical trades, or not licensed at state level at all. IN GEORGIA the relevant authority is the Division of Conditioned Air Contractors, Georgia State Construction Industry Licensing Board, Office of the Georgia Secretary of State, and duct fabrication and installation generally fall inside the mechanical or HVAC scope that body licenses. A sheet metal worker employed by a licensed mechanical contractor works under that licence; someone contracting directly for ductwork normally needs the mechanical credential in their own right. WHERE THE TRADE BOUNDARY ACTUALLY SITS. Fabricating and hanging duct is usually mechanical work. Sheet metal ROOFING and flashing is usually roofing work and can fall under a different licence entirely. Architectural metal, gutters and siding may be neither. The licence follows the application of the metal, not the material. WHAT CARRIES WEIGHT INSTEAD OF A LICENCE. A registered apprenticeship, through the U.S. Department of Labor or a joint apprenticeship committee such as SMART's, plus industry certification in welding and in testing and balancing. In a state with no sheet metal licence these are what an employer reads, and they are portable across state lines in a way a local registration is not. |
| Reciprocity | There is no Georgia sheet metal licence to reciprocate. Where the work falls inside the state's mechanical or HVAC licensing, the reciprocity of that credential applies, see the Georgia HVAC page. Registered apprenticeship completion and welding certifications travel between states on their own terms. |
| Renewal | There is no Georgia sheet metal licence to renew. Where a mechanical or HVAC credential is held, it renews on that board's cycle with whatever continuing education it requires. |
| Notes | Check which trade the specific work falls under before quoting in Georgia: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own. |
A free report on your market: what the trade pays, how that compares with nearby counties, and where your credential sits against the local licensed workforce. No account needed.
Sources: rules.sos.ga.gov, rules.sos.ga.gov, sos.ga.gov, sos.ga.gov. Always confirm current requirements with the issuing authority.
GA's register has not been re-collected in 31 days, so this page will not change tonight and the figure above stands as of August 17, 2026. Every other market ATI tracks refreshes nightly: track one and see which contractors just got licensed, added a trade, or dropped off, and pull the full record on any of them. Free trial, cancel anytime.