Requirements, license levels, and the issuing authority, sourced from New Hampshire's official board.
Check which trade the specific work falls under before quoting in New Hampshire: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own.
| Requirements | NEW HAMPSHIRE DOES NOT ISSUE A SEPARATE SHEET METAL WORKER LICENCE. Only a small number of states, Massachusetts, with its own Board of Sheet Metal Workers, is the clearest example, license this trade in its own right. Elsewhere sheet metal work is regulated as part of the mechanical trades, or not licensed at state level at all. IN NEW HAMPSHIRE the relevant authority is the No New Hampshire HVAC, air conditioning or refrigeration license. The mechanical licensing board established under RSA 153:27-a, administered by the Office of Professional Licensure and Certification, licenses fuel gas fitters and plumbers, and separately runs a voluntary certification program for oil heating installers and service personnel., and duct fabrication and installation generally fall inside the mechanical or HVAC scope that body licenses. A sheet metal worker employed by a licensed mechanical contractor works under that licence; someone contracting directly for ductwork normally needs the mechanical credential in their own right. WHERE THE TRADE BOUNDARY ACTUALLY SITS. Fabricating and hanging duct is usually mechanical work. Sheet metal ROOFING and flashing is usually roofing work and can fall under a different licence entirely. Architectural metal, gutters and siding may be neither. The licence follows the application of the metal, not the material. WHAT CARRIES WEIGHT INSTEAD OF A LICENCE. A registered apprenticeship, through the U.S. Department of Labor or a joint apprenticeship committee such as SMART's, plus industry certification in welding and in testing and balancing. In a state with no sheet metal licence these are what an employer reads, and they are portable across state lines in a way a local registration is not. |
| Reciprocity | There is no New Hampshire sheet metal licence to reciprocate. Where the work falls inside the state's mechanical or HVAC licensing, the reciprocity of that credential applies, see the New Hampshire HVAC page. Registered apprenticeship completion and welding certifications travel between states on their own terms. |
| Renewal | There is no New Hampshire sheet metal licence to renew. Where a mechanical or HVAC credential is held, it renews on that board's cycle with whatever continuing education it requires. |
| Notes | Check which trade the specific work falls under before quoting in New Hampshire: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own. |
A free report on your market: what the trade pays, how that compares with nearby counties, and where your credential sits against the local licensed workforce. No account needed.
Sources: gc.nh.gov, gc.nh.gov, www.mass.gov. Always confirm current requirements with the issuing authority.
This page is a free snapshot of New Hampshire. Track the same market every night and see which contractors just got licensed, added a trade, or dropped off, and pull the full record, with contact details, on any of them. Ask it anything, track what matters, and get the weekly intelligence email. Free trial, cancel anytime.