How to get a sheet metal worker license in Montana

Check which trade the specific work falls under before quoting in Montana: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own.

License levels in Montana

• Local mechanical registration or permit where required
• Registered apprenticeship (USDOL or joint apprenticeship committee)

Montana sheet metal worker licensing at a glance

Common questions

Do you need a license to work as a sheet metal worker in Montana?

Check which trade the specific work falls under before quoting in Montana: duct is mechanical, metal roofing is roofing, and the two can carry different licensing and different inspectors on the same building. Sheet metal workers are more often caught out by that boundary than by any licensing requirement of their own.

What sheet metal worker license levels does Montana have?

The levels are Local mechanical registration or permit where required, Registered apprenticeship (USDOL or joint apprenticeship committee).

How do you get licensed as a sheet metal worker in Montana?

MONTANA DOES NOT ISSUE A SEPARATE SHEET METAL WORKER LICENCE. Only a small number of states, Massachusetts, with its own Board of Sheet Metal Workers, is the clearest example, license this trade in its own right. Elsewhere sheet metal work is regulated as part of the mechanical trades, or not licensed at state level at all. IN MONTANA the mechanical trades are not licensed at state level either, so ductwork and sheet metal fabrication are governed by the municipality or county: a permit and inspection for the installation, and whatever contractor registration that jurisdiction requires. WHERE THE TRADE BOUNDARY ACTUALLY SITS. Fabricating and hanging duct is usually mechanical work. Sheet metal ROOFING and flashing is usually roofing work and can fall under a different licence entirely. Architectural metal, gutters and siding may be neither. The licence follows the application of the metal, not the material. WHAT CARRIES WEIGHT INSTEAD OF A LICENCE. A registered apprenticeship, through the U.S. Department of Labor or a joint apprenticeship committee such as SMART's, plus industry certification in welding and in testing and balancing. In a state with no sheet metal licence these are what an employer reads, and they are portable across state lines in a way a local registration is not.

Does Montana have sheet metal worker license reciprocity?

There is no Montana sheet metal licence to reciprocate. Where the work falls inside the state's mechanical or HVAC licensing, the reciprocity of that credential applies, see the Montana HVAC page. Registered apprenticeship completion and welding certifications travel between states on their own terms.

Related

Sources: boards.bsd.dli.mt.gov, bsd.dli.mt.gov, erd.dli.mt.gov, boards.bsd.dli.mt.gov. Always confirm current requirements with the issuing authority.